Bachmann Dynamis Betriebsanweisung PDF herunterladen (Seite 17)

Dynamis User Guide

removed from the track if using this method, or the locomotive programmed on an

isolated Service Track. Decoders that do not accept Operations Mode programming

should be programmed on a Service Track. Service mode also allows decoder CV

values to be read: this is possible using the Dynamis ProBox.

Service Mode can be any of the following according to the requirements of the

decoder:

Direct mode ‘CV’

Paged mode ’PM’

Each with or without programming track power down

Most modern decoders work with Direct mode programming. Dynamis allows any

or all of these methods to be set for a single programming session: adding modes

adds to the time taken to program. Select the programming methods required using

the System menu (see page 18).

Setting of locomotive decoder addresses i

s covered in ‘How to configure the

locomotive roster’ on page 10.

Some CVs are common to all decoders, eg CV 2 start speed or CV 29 configuration.

Others are specific to the decoder. The Handset shows the description of common

CVs.

EXAMPLE

To restrict the the maximum speed of a locomotive using Main Track programming

PROGRAM 4468

ON MAINTRACK

[ACCEPT]

POM CV 0

VAL 0 00000000

Set the value contained in CV5 to 20

POM CV 5 V HI

[<>VALUE]

VAL 20

[PROG] the chosen value is written to the decoder

[CV<>] to continue programming another CV or

[CANCEL] to return to menu

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

mPark 06 Feb 2025 | 14:31:20

Bachmann Dynamis Betriebsanweisung Seite 17